Hello!
I in fine arrives to install the eGalax driver (with just >>>sudo ./setup.sh)...
So here, I have the eeepc screen (1024x600) and the Iiyama (1024x768);
Launching eGTouchU via Terminal, it comes out;
The trick for the touch calibration is to set in "Display", the Operation Mode to "Customized", but it's needed to have in mind that if the screen resolution is (1020x768), the one of the touch sensor stays at [2048x2048], so I had to set the customized area, assuming the Iiyama at left side from the eeepc, that way: Left 0 ; Right 1024 ; Top 0 ; Bottom 2047.
And with those tunnings, the calibrating screen stays only on full Iiyama and It's possible to do it normaly...
Now I forget how to move back the Engage bar to the eeepc screen... :@)
Salutations!
